MiTAC 8050QMA Manuel de service télécharger pdf (Page 67)

50QMA

N/B Maintenance

6. Remove the two screws and lift the two hinge covers up, then free the two hinge covers. (Figure 2-18)

7. Remove the four screws, then free the LCD assembly. (Figure 2-19)

Figure 2-18 Free the two hinge covers Figure 2-19 Free the LCD assembly

1. Attach the LCD assembly to the base unit and secure with four screws.

2. Replace the antenna back into Mini PCI compartment.

3. Reconnect the two cables to the system board.

4. Replace the two hinge covers and secure with two screws.

5. Replace the top shielding and secure with seven screws.

6. Replace the top cover and secure with two screws, then reconnect the touch pad’s cable into the system board.

7. Secure with eighteen screws fasten the housing.

8. Replace the modem card, DDR, CD/DVD-ROM drive, hard disk drive, CPU, keyboard and battery pack.

(Refer to previous section reassembly)

Reassembly

MiTac Secret

Confidential Document

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 137 138

Pas de commentaire

MiTAC 8050QMA Manuel de service Page 67